Samsung Galaxy a12 (A125F) test point edl mode

     

remove FRP (Factory Reset Protection) on the Samsung Galaxy a12 (A125F) test point , you typically need to follow a series of steps involving hardware modifications and software tools. However, it’s important to note that this process may void the warranty of your device and should be performed carefully.

Here’s a general outline of the steps involved in removing FRP using the test point method:

  1. Prepare the necessary tools: You will need tools such as a soldering iron, tweezers, and a USB cable. Additionally, you may require specialized tools like a JTAG box or other hardware tools compatible with your device.
  2. Identify the test point: Locate the test point on the motherboard of your Samsung Galaxy a12 (A125F) ..
    . The test point is typically a set of solder pads or pins that need to be shorted to enter into a specific mode.

a12 test point

 

  1. Disconnect the battery: Before proceeding, ensure that the battery of your device is disconnected to avoid any potential damage during the process.
  2. Short the test point: Use tweezers or a conductive wire to short the test point on the motherboard. This action usually puts the device into a special mode, such as EDL (Emergency Download) mode or another mode required for FRP removal.
  3. Connect the device to the computer: While keeping the test point shorted, connect your Samsung Galaxy a12 (A125F)  to your computer using a USB cable. Ensure that the necessary drivers are installed on your computer for proper recognition of the device.
  4. Use compatible software tools: Once the device is connected in the special mode, you can use compatible software tools such as Odin, Miracle Box, UFI Box, z3x , unlocktool , octoplus or other similar tools to perform the FRP removal process.
  5. Follow the software instructions: The software tool you’re using should have specific instructions for removing FRP. Follow the on-screen prompts and commands provided by the software to complete the FRP removal process.
  6. Disconnect the device: After the FRP removal process is complete, safely disconnect your Samsung Galaxy a12 (A125F) from the computer and remove any hardware modifications made during the process.
  7. Reconnect the battery: Finally, reconnect the battery of your device and power it on to complete the process.

Please note that the specific details and steps may vary depending on the tools and software you use, as well as the firmware version of your device. Additionally, performing hardware modifications like test point operations requires a certain level of technical skill and caution. If you’re not confident in performing these procedures, it’s advisable to seek assistance from a professional technician.

Scroll to Top