I understand you’re looking to access the test points Xiaomi Mi 10T / 10T Pro. Test points are typically used for advanced operations such as entering EDL (Emergency Download) mode for firmware flashing or device repair. However, it’s important to note that accessing test points may void your warranty and should be done with caution.
Here’s a general step-by-step guide to accessing the test points Xiaomi Mi 10T / 10T Pro:
- Preparation:
- Ensure you have the necessary tools such as a screwdriver set, tweezers, and a spudger.
- Power off your Xiaomi Mi 10T / 10T Pro and remove the SIM tray.
- Disassembly:
- Use a heat gun or hairdryer to gently heat the back panel of your device. This helps soften the adhesive holding the back panel in place.
- Once heated, carefully insert a spudger or pry tool between the back panel and the frame of the phone. Slowly work your way around the edges to loosen the back panel.
- Lift off the back panel to reveal the internals of the device.
- Locating the Test Points Xiaomi Mi 10T / 10T Pro:
- With the back panel removed, locate the motherboard of the Xiaomi Mi 10T / 10T Pro. It’s usually the largest circuit board inside the device.
- Look for small, exposed metal pads or points labeled as test points. These points may be labeled TP1, TP2, etc., or they may not be labeled at all.
- Shorting the Test Points:
- Once you’ve located the test points, use a pair of tweezers or a conductive wire to short the test points together. This effectively creates a connection between them.
- Be very careful not to short any other components on the motherboard, as this could damage your device.
- Connecting to the Computer:
- With the test points shorted, connect your Xiaomi Mi 10T / 10T Pro to your computer using a USB cable.
- Your computer should recognize the device in EDL mode (Emergency Download Mode). You may need to install Qualcomm HS-USB QDLoader drivers on your computer if you haven’t done so already.
- With the test points shorted, connect your Xiaomi Mi 10T / 10T Pro to your computer using a USB cable.
- Performing Operations:
- Reassembly:
- After you’ve completed the necessary operations, carefully reassemble your Xiaomi Mi 10T / 10T Pro by placing the back panel back onto the device and pressing firmly around the edges to secure it in place.
Please note that accessing test points and performing advanced operations on your device carries risks and may void your warranty. Ensure you’re comfortable with the process and take necessary precautions to avoid damaging your device. If you’re unsure, it’s best to seek assistance from a professional technician.